K40,K42, K44 Carbide Standard Gear Hob with Topping or Non-Topping
2023-05-03 09:56:58
jiangxingTools
2945
K40,K42, K44 Carbide Standard Gear Hob with Topping or Non-Topping
Grade K40, K42, K44 carbide hobs are mostly used for large production, must be recoated after being resharpened.
Carbide gear hobs are offered with tooth profile DIN 3972 standard Non-Topping or Topping
module rangle for carbide hobs are M0.1-M5, OD Φ16-95, Length 8mm-180mm,bore Φ8-Φ40mm
carbide hobs for finishing cut, pre-grinding, pre-shaving, modified, chamfering, spline shaft, timing pulley, rectangular spline,triangular spline, worm/ratchet,etc special profile.
相关文章
-
Gear hobs for synchroflex timing belt pulleys
Gear hobs for synchroflex timing belt pulleystopping cutterquality grade A to DIN3968single start, r... - Precision Gear Cutting Tools and Gear Hobs with G30, G50, G90 Material
- PA20° Standard Gear Milling Cutter with Module m0.4
- Nominal PCD 180mm M2 Gear Shaving Cutter with PA20°
- PA30° DIN5480 Involute Spline Hob with Module m10
- PA20° Profile DIN3972 Standard Pre-grinding Hob with Module m3.25
- Small Module Taper Shank Gear Shaper Cutter
