Chamfer for Gear Hobbing Tools
2021-11-26 14:35:09
jiangxingTools
3259
Chamfer for Gear Hobbing Tools
When hobbing helical spur gears with large diameters, the hobs cannot always be chosen long enough to cover the entire working area. To prevent excessive wear of the hob teeth in the approach area, the gear hob is produced with a tapered chamfer. For gears with double-helical teeth, two hobs with chamfer may be needed, if the distance between the two tooth rows is relatively small.
Depending on whether hobbing is by the climb or conventional method, the chamfer — generally 5 to 6 x module long and 5° to 10° angle of inclination — is situated on the entering- or leaving end of the cutter. Any more details on quality gear hobbing tools, please visit our new wbesite.
相关文章
-
Module and DP Gear Hobs with 14°30′ – 45°
Module and DP Gear Hobs with 14°30′ – 45°Module : 0,1 – 40DP : 120 – 0,75PA : 14°30′... - Gear Milling Cutters for Spur Gears
- Involute Spline Gear Hob with DIN 5482
- Timing Pulley Hob for HTD 14M
- PA20° Standard Gear Milling Cutter with Module m11
- PA20° Pre-shaving Hob Cutter with Module m3.25
- PA20° Standard Involute Gear Milling Cutter with Module m0.6
